Sustainable® 6000

Supplier: Trellis Bioplastics
GENERAL INFORMATION
Product type:
Thermoplastic >> PLA (Polylactide) >> Polylactide (Polylactic Acid) [PLA]
  • Labels & Ratings
  • TSCA Inventory List
  • Canada DSL Inventory List
  • EU EINECS List
  • China inventory of Existing Chemical Substances List

Product performance

Sustainable® 6000 is a bio-based PLA (polylactic acid) blend resin containing biodegradable polymers. Exhibits an excellent balance of strength, toughness and processability. Moreover, it can replace... 

  • Physical Form
  • Pellets
  • Material Status
  • Commercial
PROPERTIES
Impact Properties
Value
Test Conditions
Test Method
Gardner Impact
ASTM D 5420
Mechanical Properties
Value
Test Conditions
Test Method
Flexural Modulus
ASTM D 790
Flexural Strength
ASTM D 790
Tensile Elongation
ASTM D 638
Tensile Modulus
ASTM D 638
Tensile Strength (Tensile Stress)
ASTM D638
Physical Properties
Value
Test Conditions
Test Method
Melt Mass-Flow Rate (MFR or MFI = Melt Flow Index or MI = Melt Index)
ASTM D1238
Melt Mass-Flow Rate (MFR or MFI = Melt Flow Index or MI = Melt Index)
ASTM D1238
Specific Gravity (Density)
ASTM D792
CONVERSION MODE & PROCESSING GUIDELINES
Conversion Mode
Extrusion
Thermoforming/ Vaccuum forming
Extrusion>>Sheet
Extrusion - Adapter Temperature
165 - 175 °C
Extrusion - Die Temperature
165 - 175 °C
Extrusion - Drying Temperature (Crystallized)
70 - 80 °C
Extrusion - Drying Temperature (Regrind)
40 - 50 °C
Extrusion - Drying Time
2 - 4 hr
Extrusion - Feed Temperature
155 - 175 °C
Extrusion - Front Zone
165 - 175 °C
Extrusion - Melt Temperature
200 °C
Extrusion - Middle Zone
160 - 170 °C
Extrusion - Screw Speed
20 - 100 rpm
1. Standard closed loop desiccant based column driers are recommended.
2. Moisture content of less than 400 ppm is recommended.
3. The dew point of the air at the input of the hopper should be -40°F or lower.
4. Temperatures above 220°C should be avoided.
Back to Top