Mvera™ B5002

Supplier: BIO FED
GENERAL INFORMATION
Product type:
Thermoplastic >> PHA (Polyhydroxyalkanoate)
  • Labels & Ratings
  • OK Compost
  • ASTM D6400 (Biodegradable),

Product performance

Polyhydroxyalkanoate. It is a compostable film grade blend resins made with Mirel biopolymer. Film properties, rheology and run bubble similar to LDPE. Possesses good dart and tear resistance, high... 

  • Material Status
  • Commercial
PROPERTIES
Fill Analysis Properties
Value
Test Conditions
Test Method
Melt Viscosity
ASTM D3835
Films Properties
Value
Test Conditions
Test Method
Dart Drop Impact
ASTM D1709
Elmendorf Tear Strength
ASTM D1922
Elmendorf Tear Strength
ASTM D1922
Tensile Strength (Tensile Stress)
ASTM D882
Tensile Strength (Tensile Stress)
ASTM D882
Tensile Toughness
ASTM D882
Tensile Toughness
ASTM D882
Mechanical Properties
Value
Test Conditions
Test Method
Coefficient of Friction
ASTM D1894
Tensile Elongation
ASTM D882
Tensile Elongation
ASTM D882
Tensile Modulus
ASTM D882
Tensile Modulus
ASTM D882
Physical Properties
Value
Test Conditions
Test Method
Specific Gravity (Density)
ASTM D792
Thermal Properties
Value
Test Conditions
Test Method
Melting Temperature (Melting Point)
Melting Temperature (Melting Point)
CONVERSION MODE & PROCESSING GUIDELINES
Conversion Mode
Extrusion >> Films (cast)
Extrusion >> Films (blown)
Extrusion - Blown Film Air Ring (Blown Film)
60 °C
Extrusion - Die Temperature
165 °C
Extrusion - Drying Temperature
80 °C
Extrusion - Drying Time
4 hr
Extrusion - Front (metering) Temperature
160 °C
Extrusion - Low Compression Ratio
< 3
Extrusion - Middle (solids conveying) Temperature
165 °C
Extrusion - Primary Casting Roll
50 - 65 °C
Extrusion - Rear (solids conveying) Temperature
190 °C
Extrusion - Suggested Max Moisture
0.08 - 0.15 %
Extruder Barrel Settings= Reverse Temperature Profile,

Products with same tradename

Mvera™ B5010

Mvera™ B5011

Back to Top