Grilamid® XE 3976 Black 9992

Supplier: EMSGrivory EMS Group
GENERAL INFORMATION
Product type:
Thermoplastic >> PA (Polyamide, Nylon) >> Polyamide 6-10 (Nylon 6-10) [PA 6-10 (Nylon 6-10)]

Product performance

Grilamid® XE 3976 Black 9992 is a 30% glass fibre reinforced, heat stabilized polyamide 6-10 injection molding grade based on renewable resources. Its main features include low water absorption, good... 

  • Appearance
  • Black
  • Material Status
  • Commercial
PROPERTIES
Electrical Properties
Value
Test Conditions
Test Method
Comparative Tracking Index
IEC 60112
Surface Resistivity
IEC 60093
Volume Resistivity
IEC 60093
Flammability Properties
Value
Test Conditions
Test Method
Flame rating (UL 94)
ISO 1210
Impact Properties
Value
Test Conditions
Test Method
Charpy Notched Impact Strength
ISO 179/1eU
Charpy Notched Impact Strength
ISO 179/1eU
Charpy Unnotched Impact Strength
ISO 179/1eU
Charpy Unnotched Impact Strength
ISO 179/1eU
Mechanical Properties
Value
Test Conditions
Test Method
Tensile Elongation
ISO 527
Tensile Modulus
ISO 527
Tensile Strength (Tensile Stress)
ISO 527
Physical Properties
Value
Test Conditions
Test Method
Specific Gravity (Density)
ISO 1183
Thermal Properties
Value
Test Conditions
Test Method
CLTE (Coefficient of Linear Thermal Expansion) - Flow
ISO 11359
CLTE (Coefficient of Linear Thermal Expansion) - Flow
ISO 11359
Heat Deflection Temperature Under Load (HDT)
ISO 75
Heat Deflection Temperature Under Load (HDT)
ISO 75
Max. Continuous Use Temperature
ISO 2578
Max. Continuous Use Temperature
ISO 2578
Melting Temperature (Melting Point)
ISO 11357
CONVERSION MODE & PROCESSING GUIDELINES
Conversion Mode
Injection molding - thermoplastics
Injection - Clamping Force
7.5 kN x projected area cm2
Injection - Dew Point of the dryer
-30 °C
Injection - Drying Temperature
< 80 °C
Injection - Drying Time
4 - 12 hr
Injection - Dynamic Pressure
5 - 15 bar
Injection - Flange Temperature
70 - 90 °C
Injection - Groove
2.0 - 5.0 mm
Injection - Heating Zones
300 °C
Injection - Holding Pressure
300 - 800 bar
Injection - Nozzle Temperature
< 265 °C
Injection - Processing (Melt) Temp
260 - 280 °C
Injection - Screw Compression Ratio
2 - 2.5
Injection - Screw Length
18 - 22 D
Injection - Screw Speed
50 - 100 min-1
Injection - Shoulder Width
1.5 - 2 mm
Injection - Speed
medium - high
Injection - Tool Temperature
70 - 90 °C
Injection - Vent Depth
< 0.02 mm
Injection - Zone 1 Temperature
240 - 260 °C
Injection - Zone 2 Temperature
250 - 270 °C
Injection - Zone 3 Temperature
260 - 280 °C
Back to Top