Researchers Combine PAN & Lignin for Automobile-grade Carbon Fiber Production

SpecialChem - August 31st, 2017
Researchers develop lignin-based carbon fiber for automotive industry. Using plants and trees to make products such as paper or ethanol leaves behind a residue called lignin, a component of plant cell walls.

That leftover lignin isn’t good for much and often gets burned or tossed into landfills. Now, researchers report transforming lignin into carbon fiber to produce a lower-cost material strong enough to build car or aircraft parts.

The researchers presented their work at the 254th National Meeting & Exposition of the American Chemical Society (ACS).

Ways to Use Leftover Lignin

“Lignin is a complex aromatic molecule that is mainly burned to make steam in a biorefinery plant, a relatively inefficient process that doesn’t create a lot of value,” says Birgitte Ahring, Ph.D., the principal investigator on the project. “Finding better ways to use leftover lignin is really the driver here. We want to use biorefinery waste to create value. We want to use a low-value product to create a high-value product, which will make biorefineries sustainable.”

Carbon fiber

Carbon fiber made with lignin would be more sustainable and less expensive than fibers currently being produced. The carbon fiber found in modern cars and aircraft are typically made from polyarylonitrile (PAN), which is a pricey, non-renewable polymer.

“PAN can contribute about half of the total cost of making carbon fiber,” Jinxue Jiang, Ph.D., says. He is a postdoctoral fellow in the Ahring laboratory at Washington State University. "Our idea is to reduce the cost for making carbon fiber by using renewable materials, like biorefinery lignin." Other researchers have tried to make carbon fibers from 100 percent lignin, Jiang says, but ended up with a fiber too weak for the automotive industry. "We wanted to combine the high strength of PAN with the low cost of the lignin to produce an automobile-grade carbon fiber."

To develop a strong yet cheap carbon fiber, Ahring’s team mixed lignin with PAN in varying amounts, from 0 to 50 percent. They melded the polymers together into a single fiber using a process called melt spinning. “You elevate the temperature of the polymer blend until it melts, so it can flow,”Jiang says. “Then, you spin these polymer melts until the fiber forms.”

Fibers’ Structural and Mechanical Characteristics

Using a variety of methods, including nuclear magnetic resonance spectroscopy, calorimetry and electron microscopy, the researchers evaluated the fibers’ structural and mechanical characteristics.

They found that they could get away with as much as 20-30 percent lignin without sacrificing strength. The lignin carbon fibers could, the researchers say, have automobile applications such as internal parts, castings and tire frames.

Sustainable and Less Expensive

As a next step, the researchers will be taking their fibers to an automobile manufacturing plant to test their strength in a real-world scenario. “If we can manage to get a fiber that can be used in the automobile industry, we will be in a good position to make biorefineries more economically viable, so they can sell what they usually would discard or burn,” Ahring says. “And the products would be more sustainable and less expensive.”

Funding for the research comes from the National Science Foundation Center for Bioplastics and Biomaterials along with Ford and Hyundai Motor Companies.

Source: American Chemical Society
Back to Top